Nov 04, 2018 · This heat exchanger has two types which are:sensible heat exchanger which recovers only sensible heat and enthalpy heat exchanger which utilizes membrane and recovers both sensible and latent heat (dehumidify the supplied air).
Air-to-air heat exchanger can recover sensible energy (temperature) or/and latent energy (moisture), as mentioned before. Thus, air-to-air heat exchanger units can be generally distinguished to heat recovery ventilators (HRVs) and energy recovery ventilators (ERVs). HRVs are used for sensible heat exchange applications and
Energy Wheels vs Plates - Pittsburgh Air Systemsload is 0% sensible and 100% latent). The plate heat exchanger would have an effectiveness of 0% in this case. Fan power would be spent pushing air through the plates, but no benefit would be realized. Transferring the latent energy at part load is extremely important for maintaining proper indoor humidity levels. Keep in mind, systems operate at part
ERV can transfer two types of heat:sensible and latent. Sensible heat refers to the heat content of the air itself, which can be measured with a standard thermometer. Latent heat is the amount of energy that is required to evaporate water into water vapor (humidity) and is required to remove that water from the water vapor via condensation. Latent heat can be measured by a wet-bulb thermometer.
Heat Recovery Efficiency - Engineering ToolBoxThe fluid is circulated to a heat exchanger in the make-up air where the heat is transferred to the supply air. Both sensible and latent heat may be transferred. Latent heat when moisture in the outlet air condensates in the heat exchanger. The moisture is not transferred.
Hoval plate heat exchangers do not transmit moisture but still can use part of the latent heat of moist extract air. At low outside temperatures, when there is a high heat demand, the extract air is cooled down to such a degree that the satura-tion temperature is reached and condensation is formed. Thus the latent heat of evaporation is released.
Simulation Model Air-to-Air Plate Heat ExchangerThe available models for air-to-air plate heat exchangers usually do not take the dependence of the convective heat transfer coefficient on the air mass flow and temperature into account ([Brandemuehl et.al. 93], [TRNSYS 96]). However, this dependence should not be neglected if the air flow over the heat exchanger
air-to-air heat exchanger used to recover energy:where: = sensible, latent, or total effectiveness x 1 =dyr bbu (l °F), humidity ratio (gr/lb), or enthalpy (Btu/lb) of entering supply air x 2 =dyr bbu (l °F), humidity ratio (gr/lb), or enthalpy (Btu/lb) of leaving supply air x 3 =dyr bbu (l °F), humidity ratio (gr/lb), or enthalpy (Btu/lb) of
Fixed plate heat exchanger for Daikin air handlersFixed plate heat exchanger for Daikin air handlers Clean air solutions for a wide variety of commerical building applications Fixed plate benefits No moving parts Balanced humidity loads and no cross contamination High sensible and latent recovery Flexible sizing, multi-core avail-ability No condensation/freeze tolerant Anti-microbial protection
Proud to be serving the Machining Platform you can trust