PTFE modified FL2020 - High friction & wear resistance - Low specific wear rate MoS 2 filled FM2020 FM2520S - Medium viscosity - Low specific wear rate in condition of high load, low speed and against metal - For bearing, bush parts Special lubricant package TX-11H TX-21 TX-31 - High friction and wear resistance - Reduced noise NX-20 - High friction and wear resistance - Reduced noise
Dec 01, 2007 · High-strength, wear- and corrosion-resistant PTFE composites are needed for conduit pipes, pump impellers, paddings and gaskets, as well as piston rings for compressors, which are exposed to wet or corrosive environments, for all of which tribological performance of PTFE composites
PTFE Bushings - DCWGraphite Filled PTFE:Up to 25%:Improve wear resistance, decrease friction and increase sliding properties against soft metals- chemical inertness. Improve the temperature resistance in some way. Black:Bronze Filled PTFE:Up to 60%:Improved compression strength, wear resistant, high thermal conductivity, resistance to abrasion. Reduced
Bronze Filled PTFE. Up to 60%. Improved compression strength, wear resistant, high thermal conductivity, resistance to abrasion. Reduced chemical resistance. Dark Brown. Molybdenum disulphide (MoS2) Filled PTFE. up to 5%. Increased PTFE properties of hardness and wear resistance. Increased sliding properties and decrease friction.
Properties of PTFE - PolytetrafluoroethyleneGraphite Filled PTFE:15:Yes High compressive strength Improved wear resistance under load & permanent deformation Better thermal / electrical conductivity. Good chemical resistance Improved frictional properties. Shaft bearings in chemical high speed Chemical pumps. Bronze Filled PTFE (oxidized / Non-oxidized) 40 - 60:Yes
performance, at the same time it required to add the filler to improve the creep resistance of PTFE material and compression strength, so the whisker has a certain length to diameter ratio is the ideal choice. Tribological performance of PTFE filled with POB In order to intensify the tribological behavior of POB-PTFE composites by whisker filled, it is necessary first to carry out the influence law of POB content on the tribological properties of PTFE.
TABLE OF CONTENTS - KOLON PLASTICSKOCETAL®is highly crystalline and has excellent balance of mechanical toughness and rigidity. It is also resistant to fatigue, creep, and has good wear and abrasion resistance by its self-lubricating property. However, due to a glass transition temperature about -60°C, the change in mechanical properties with temperature is relatively large.