In the European heat pump design the heat exchanger in contact with the energy source is the evaporator, while the heat exchanger producing the hot water is the condenser. As with all modern heating and cooling systems, the aim is maximum effi ciency. In a heat pump, this is achieved by ensuring the closest possible temperature approach between the evaporator and the condenser.
When included, the sequenced Heating equipment set associated with a heat transfer loop meets remaining load after heat available from any included solar water heater (SWH), water source heat exchanger (WSHX), condenser heat recovery (CHR), air-to-water heat pump (AWHP), or combined-heat & power (CHP) system have been fully utilized.
Heat pumps - SWEPIn air source (AtW) heat pumps, outdoor/exhaust air is used as the heat source in an air coil to evaporate the refrigerant. After the compressor, the energy is released into a water circuit that is used to provide comfort heating or to heat tap water, in a similar way to the GSHP condenser. At low ambient air temperatures, the evaporation temperature of the air coil falls below the freezing point of water.
Thus, the reboiler becomes the condenser and the column condenser becomes the evaporator in a heat pump system. The column design is unchanged, but the heat exchanger design is different from a conventional distillation column operational standpoint.
Heat Exchangers and Heat Pumps - LAKOS Filtration SolutionsHeat Exchanger Protected by LAKOS Separator. Industrial Electric Heating Company of Columbus, Ohio manufacturers and sells metal parts and components that are hardened by heating to temperatures of 1600-1800 degrees. Through the heating and cooling process of these parts, slag particles can foul the systems heat
Proud to be serving the Machining Platform you can trust