Air-to-Air Industrial Dimple Plate Heat Exchangers. The Dimple Plate (DPL) unit is our most versatile, rugged, heavy-duty, yet cleanable plate heat exchanger. The DPL utilizes dimples on each plate to maintain plate spacing and enhance turbulence while operating at lower pressure drop. Our DPL is an all welded plate type heat exchanger with the
Company Profile - HEAT EXCHANGERS from APEX GroupAPEX, CORPEX & A-CORREX plate-type and C-PEX tubular exchangers operate as combustion air preheaters, gas/gas preheaters, gas coolers, heat recovery from incinerators, gas turbine exhaust recovery and DeNOx installations. The products are continuously developed based on in-house research and feedback from customers.
The tool greatly simplifies heat exchanger selection by providing the following capabilities:Selection capability for Bell & Gossett BPX (brazed plate) and GPX (gasketed plate) heat exchangers. Option to design GPX units to the requirements for ASHRAE 90.1 compliance. Double wall designs for potable water selections.
Plate Heat Exchanger with Diffuser Channels SpringerLinkSep 02, 2020 · Plate heat exchangers, according to [ 6 ], are used most widely with liquid-liquid coolants at working pressure of 2 MPa and temperature below 150°C. Table 1 presents the channel parameters adopted in the calculations of heat exchangers with diffuser channels and channels with a constant cross section. Table 1.
Plate type air heat exchanger plated-finned type, Roiling-Type, Coiling-Type, Adhering to the corporate spirit of Establishing Business through Good Faith and Winning through High Quality and the philosophy of Continuous Development and Constant Innovation
Plate Type Heat Exchanger Contact, Plate Type Heat Leading Plate Type Heat Exchanger and suppliers, providing solutions for all sorts of Plate Type Heat Exchanger techniques using latest heat exchangers equipments in India
Heat Exchanger Thermodynamics
Alfa Laval - Gasketed plate-and-frame heat exchangersIn a gasketed plate heat exchanger, the plates are fitted with elastomeric gaskets which seal the channels and direct the media into alternate channels. The plate pack is assembled between a frame plate and a pressure plate, and compressed by tightening bolts fitted between these plates. The channel plates and the pressure plate are suspended
Plate Heat Exchangers, Heat Exchanger, Air Cooled Heat Feb 23, 2018 · The plate heat exchanger (PHE) was invented by Dr Richard Seligman in 1923 and revolutionized methods of indirect heating and cooling of fluids. Plate Type Heat Exchanger. Plate type heat exchanger one is composed of multiple, thin, slightly-separated plates that have very large surface areas and fluid flow passages for heat transfer.