Smoke with temperature of around 350 DEG C out of the gas-gas heat exchanger for the annealing furnace can goes into the heat recovery boiler effectively and supply heat transfer completely for
Design of Heat Exchanger for Waste Heat Recovery from Jan 01, 2018 · For the experimental setup with heat exchanger it is clear that there is reduction in smoke level when engine is operating at 23Â° before TDC with heat exchanger as compared to engine operating at normal operating conditions. The values of smoke density at full load were 14% and at overload it was 22%. 5.
Sep 19, 2009 · That's a waste of energy and something a heat exchanger can certainly reduce (though not eliminate entirelysome heat is always going to be lost). The way to solve this problem is with heat exchangers positioned inside the exhaust tail pipes or smokestacks.
Design of Heat Exchanger for Waste Heat Recovery from The heat exchanger designed for the purpose of recovering the waste heat from the exhaust gases and to heat the inlet air up to 150C at full load by using this heat is working satisfactorily. The inlet air heating improves the performance of the stationary diesel engine and lowers down the emission level. The effectiveness of heat exchanger found to be 0.615 at full load condition.
Proud to be serving the Machining Platform you can trust